TT Roadster L4-2.0L Turbo (BPY) (2008)
-
Disengage wiring harness - 2 - from bracket.
-
Remove bolts - 3 -.
‹› Do not pull out Camshaft Adjustment Valve 1 (N205 ) at connector.
-
Remove bolts - arrows - and remove Camshaft Adjustment Valve 1 (N205) from housing.
Installing
‹› Tightening torque => [ Cylinder Head Assembly Overview ] See: Engine, Cooling and Exhaust/Engine/Cylinder Head Assembly/Service and
Repair/Cylinder Head Assembly Overview
‹› Camshaft Adjustment Valve 1 (N205) as well as housing must be free of dirt and contamination.
‹› Remove new Camshaft Adjustment Valve 1 (N205) from packaging only prior to installation.
CAUTION!
‹› The Camshaft Adjustment Valve 1 (N205) must not experience any hits or impacts.
-
Coat sealing ring with engine oil.
-
Carefully insert Camshaft Adjustment Valve 1 ( N205) into housing and press it in perpendicular to valve axle by hand as far as stop.
-
Install bolts and tighten to 4 Nm with Torque Wrench (V.A.G 1783), Ratchet Adapter 1/4 (VAS 6234 ),TORX-Bit T20 and bit holder from TORX
bit set (V.A.G 1766).
The rest of assembly is in reverse order of disassembling sequence.