TT Roadster L4-2.0L Turbo (BPY) (2008)
Specified value: 12.5. battery voltage.
If the specified value was not obtained:
-
Using a Multimeter, check the Engine Component Power Supply Relay (J757) socket 3/86 to the Motronic Engine Control Module (ECM) Power
Supply Relay (J271 ) socket 2/87 for an open circuit or short to Ground (GND).
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the wiring connection.
If no malfunctions are found in the wiring:
Checking Ground (GND)
-
Using a Multimeter, check the Engine Component Power Supply Relay (J757) socket 5/85 to the Engine Control Module (ECM) (J623) electrical
harness connector terminal T94/32 for resistance.
Specified value: 1.5 ohms.
If the specified value was not obtained:
-
Check the Engine Component Power Supply Relay ( J757) socket 5/85 to the Engine Control Module (ECM) (J623) electrical harness connector
terminal T9432 for an open circuit or a short to Battery (+) or to Ground (GND).
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the wiring connection.
If no malfunctions are found in the wiring and the voltage supply was OK:
-
Replace the Engine Component Power Supply Relay ( J757).
-
Perform a road test to verify repair.
If the fault does not return:
Repair complete, Generate readiness code. Refer to => [ Readiness Code ] See: Computers and Control Systems/Testing and Inspection/Monitors,
Trips, Drive Cycles and Readiness Codes.
-
End diagnosis.
If the fault does return and no malfunction is detected in the wiring and the voltage supply was OK:
-
Replace the Engine Control Module (ECM) (J623 ). Refer to => [ replacing ] See: Computers and Control Systems/Engine Control
Module/Testing and Inspection/Engine Control Module (ECM) (J623).
-
Assembly is performed in the reverse of the removal.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09/Diagnostic Mode 03 - Read DTC Memory.
2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09/Diagnostic Mode 04 - Erase DTC Memory.
3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Computers and Control Systems/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.
End diagnosis.