TT Roadster L4-2.0L Turbo (BPY) (2008)
-
At Steering Column Electronic Systems Control Module (J527), slide a dia. 2.5 mm drill - item 2 - approximately 45 mm into the hole - arrow 1 -,
releasing the retaining detent - arrow 2 -.
-
Pull Steering Column Electronic Systems Control Module (J527) down slightly and remove drill.
-
Release retaining clip - arrow - on connector side of Steering Column Electronic Systems Control Module (J527 ) and remove control module
from steering column switch module.
Installing
‹› Tightening specification, refer to => [ Steering Column Switch Module Assembly Overview ] See: Steering Column Switch Module Assembly
Overview.
Install in reverse order of removal, observing the following:
-
Install steering column trim. See: Steering/Steering Column
-
Install steering wheel. See: Steering/Steering Wheel
-
Install airbag unit.