TT Roadster L4-2.0L Turbo (BPY) (2008)
Tightening of the respective bolts/nuts must then only occur after dimension - a -, which was measured before installation between the wheel hub
center and the lower edge of wheel housing, has been attained
CAUTION!
‹› Do not lift or lower vehicle with engine/transmission jack below vehicle.
‹› Do not leave (V.A.G 1383 A) below vehicle any longer than necessary.
-
Tighten respective bolts/nuts.
-
Lower wheel bearing housing.
-
Move engine and transmission jack away from under vehicle.
-
Remove (T10149).