TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
Trunk / Liftgate Shock / Support: Procedures
Rear Lid Gas-Filled Strut, Venting, Roadster
Rear Lid Gas-Filled Strut, Venting, Roadster
Venting
-
Clamp gas-filled strut in a vise in area - x - = 50 mm (2 in.).
CAUTION!
‹› Clamp only within this area, otherwise accident could occur!
‹› Wear protective eyewear when sawing.
‹› Cover area of sawn portion with a rag to absorb oil spraying out.
-
Cut through cylinder of gas strut within first third of cylinder's overall length using piston rod end of cylinder as reference point.