TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
‹› Both bolt heads - 2 - must be parallel to edge of support arm - 3 -.
‹› A distance of - x - = 16 mm must be present between engine mount - 1 - and engine support - 4 -.
‹› Distance - x - = 16 mm can also be checked with corresponding round stock.
-
Tighten subframe mount bolts on the transmission side.
-
On transmission side, edges of support arm - 1 - and transmission mount - 2 - are parallel.
‹› Dimension - x - same size on both sides of bracket.
-
Tighten subframe mount bolts on the engine side.
The rest of the installation is in reverse order of removal, note the following:
‹› The hose supports, air guide pipes and hoses must be free of oil and grease before installing.
‹› Secure all hose connections with hose clamps appropriate for the model.
-
Tighten bolts for front part of longitudinal member.
-
Remove engine support bridge (10 - 222 A).
-
Install front right coolant pipe. Refer to => [ Right Front Coolant Pipe ] See: Engine, Cooling and Exhaust/Cooling System/Coolant
Line/Hose/Service and Repair/Right Front Coolant Pipe.
-
Install air filter housing and the air filter.