TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
Trim Panel: Service and Repair
Rear Bulkhead Cover
Rear Bulkhead Cover
Special tools, testers and auxiliary items required
‹› Trim Removal Wedge (3409)
Removing
-
Move both seats forward and fold backrests forward.
-
Remove driver's and passenger's seat belts from outer floor assembly mounting point. Refer to => [ Outer Floor Assembly Anchorage Point ] See:
Restraint Systems/Seat Belt Systems/Seat Belt/Service and Repair.
‹› Both linkage removal flaps - 1 - are closed when in basic position.
-
Carefully unclip rear bulkhead cover - 2 - forward in area of both rollover protectors - 3 - using Trim Removal Wedge (3409).
-
Then remove rear bulkhead cover - 2 - upward - direction of arrow - from body and from wind deflector or wind deflector support.
Installation
To install, perform the steps used in removal in reverse order. Observe the following when doing so:
‹› There are clamps - 2 - and - 3 - for the rear bulkhead cover - 1 - that must be inserted in the cover and clamps => [ (Item 6) Clips ] See: Service
and Repair/Removal and Replacement that must be placed in the rollover protection trim (body).