TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
-
It should no longer be possible to remove protective cap from brake caliper housing by hand.
-
Thinly coat piston and seal with lithium grease ( G 052 150 A2) before inserting.
-
Lift brake piston, as shown, with commercially available extension and ratchet adapter and lightly press against protective cap.
Do not angle piston, to avoid damaging seal sleeve.
-
Blow protective cap on with pressurized air (max. 3 bar). The protective cap will thereby jump over the brake piston.
Use protective backings
-
Press piston into \ brake caliper housing by hand.
‹› The inner sealing lip of the protective cap thereby slips into the groove on the piston.