TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
‹› 10 Nm
3 - Protective cap
4 - Guide pins
‹› Grease before pulling on protective cap
5 - Protective cap
‹› Pull onto brake carrier and guide pin
6 - Brake carrier with guide pins and protective cap
‹› Supplied as pre-assembled replacement part with sufficient grease on guide pins
‹› If protective caps or guide pins are damaged, install repair kit. Use supplied grease packet to lubricate guide pins.
7 - Protective cap
‹› Pull onto piston with outer sealing lip
8 - Piston with automatic adjustment
‹› Removing and installing => [ Rear Brake Caliper Piston ] See: Overhaul/Rear Brake Caliper Piston.
‹› Apply thin coat of lithium grease (G 052 150 A2 ) to piston
9 - Sealing ring
‹› Do not damage when installing piston
‹› Removing and installing => [ Rear Brake Caliper Piston ] See: Overhaul/Rear Brake Caliper Piston.
10 - Brake caliper housing with parking brake cable lever
‹› Replace if leaking at parking brake cable lever
‹› Pre-bleed caliper housing after repairing => [ Pre-Bleed Brake Caliper ] See: Overhaul/Rear Brake Caliper Piston.