TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
7
Oil Baffle
8
Bolt
‹› 20 Nm
9
Bolt
‹› 8 Nm
10
Oil Intake Pipe
‹› Clean strainer if contaminated
11
O-Ring
‹› Replace
12
Bolt
‹› Replace
‹› Different bolt lengths => [ Balance Shaft Housing Bolts ]
‹› For tightening specification and sequence, refer to => [ Balance Shaft Housing Tightening Specifications and Sequence ]
13
Bolt
‹› Replace
‹› Different bolt lengths => [ Balance Shaft Housing Bolts ]
‹› For tightening specification and sequence, refer to => [ Balance Shaft Housing Tightening Specifications
and Sequence ]
14
Outer Rotor
‹› Check contact surfaces for groove build-up
‹› Marking must be visible
15
Inner Rotor
‹› Check contact surfaces for groove build-up
16
Oil Pump Cover
‹› Remove chain tensioner - 19 - to remove
17
Chain Sprocket
‹› Only possible to install in one position
18
Bolt
‹› Replace
‹› 20 Nm plus an additional 90° turn
19
Chain Tensioner with Tensioning Rail
‹› Remove the balance shaft module to remove. Refer to => [ Balance Shaft Module with Oil Pump ] See: Balance Shaft Module with Oil Pump.
‹› Pretension to install. Refer to => [ Tension the chain tensioner if necessary: ] See: Balance Shaft Module with Oil Pump