TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
-
Replace the Motronic Engine Control Module (ECM) (J623).
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09.
2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09.
3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Computers and Control Systems/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.