TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
-
Pull retainer - 2 - in - direction of arrow - and disconnect connectors - 1 - and - 3 -.
-
Remove nuts - 2 - from left - 3 - and right supports - 4 -.
-
Loosen nuts - 5 - approximately 3 turns and remove driver side knee airbag - 1 - toward rear.
-
Place airbag unit - 1 - so padding faces upward.
Installation
To install, perform the steps used in removal in reverse order. Observe the following when doing so:
CAUTION!
‹› Observe safety precautions for work on airbags. Refer to => [ Airbag System General Safety Precautions ] See: Service Precautions.
‹› Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "discharge static electricity". This
can be done by touching door striker, for example.
-
Slide knee airbag - 1 - on left - 3 - and right - 4 - supports as far as stop.