TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
-
Switch the ignition on.
-
Using a multimeter, check the Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) (G130) electrical harness connector terminals
3 to 4 for voltage.
Specified value: 0.400 to 0.500 Volts
-
Switch the ignition off.
If the specified value was not obtained:
-
Replace the Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) ( G130). Refer to the appropriate service manual.
If the specified value was obtained:
Checking wiring
If the manufacturers test box is being used, perform the following step.
-
Install the test box.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623).
-
Using a multimeter, check the Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) ( G130) electrical harness connector
terminals to the Motronic Engine Control Module (ECM) (J623) electrical harness connector T94 terminals for an open circuit according to the
wiring diagram.