TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
The pressure hose and the Seat Occupied Recognition Mat - 1 - must not be kinked under any circumstances during repairs.
-
Remove the complete service kit.
Installation
CAUTION!
‹› Observe safety precautions for work on airbags. Refer to => [ Airbag Safety Precautions ] See: Restraint Systems/Air Bag
Systems/Air Bag/Service Precautions.
‹› Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "discharge static electricity". This
can be done by touching door striker, for example.
Service kit, installing
‹› The hard foam insert in the crease is not included in the service kit. Therefore, reuse the hard foam insert again in the seat crease.
-
Guide Seat Occupied Recognition Pressure Sensor ( G452) and Seat Occupied Recognition Control Module (J706) from above through seat pan
without disconnecting connectors.
CAUTION!
The pressure hose and the Seat Occupied Recognition Mat - 1 - must not be kinked under any circumstances during repairs.
-
Pull the crease between seat pan and Seat Occupied Recognition Mat - 1 - so that it is smooth (free of folds).
-
Secure the Seat Occupied Recognition Mat - 1 - with the clips - 2 - and - 3 - (quantity: 2).
-
Secure Seat Occupied Recognition Pressure Sensor (G452) - 4 -.