TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
-
For the repair, use two suitable crimp connectors form the Wiring Harness Repair Set (VAS 1978A).
-
Use the Crimping Pliers (Base Tool) (VAS 1978/1-2 ) to press the crimp connector.
The following exchangeable heads are available for the Crimping Pliers (Base Tool) (VAS 1978/1-2):
‹› Exchangeable Head, 0.35-2.5mm (VAS 1978/1-1)
‹› Exchangeable head, 4.0-6.0 mm² (VAS 1978/2 A )
-
Slide the crimp connector onto the vehicle-specific single wire at one side and onto repair wire at the other side.
-
Crimp the crimp connection at both wire ends using crimp pliers.
-
Repeat this procedure on the other wire ends.
‹› Do not crimp wire insulation.
After crimping, crimp connections must be heat-shrunk using hot air gun to prevent moisture penetration.