TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
Punch points must be applied 2 graduation lines next to the drill out punch points.
-
Mark one graduation line of adjustment screw on the steering gear housing - 1 -.
-
Remove the adjustment screw 6 graduation lines toward left - 2 -.
While doing this, a loosening torque of at least 15 Nm must be obtained.
If loosening torque is not obtained:
-
Tighten adjustment screw to 40 Nm again.
-
Reinforce the 6 peenings using a punch.
-
Check applied marking of adjustment screw graduation line on steering gear housing, re-apply marking if necessary.
-
Remove the adjustment screw 6 graduation lines toward left.
A loosening torque of at least 15 Nm must be obtained.
-
Remove rubber plug from adjustment screw.
-
Attach a dial gauge with 0.001 graduations as depicted in the illustration.