TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
![background image](/audi/tts_quattro_roadster/l4-2.0l_turbo_(cdma)/Page-937007.png)
-
Remove the driveshaft from the rear final drive and lower it onto the Engine/Transmission Jack (V.A.G 1383 A).
-
When removing and installing the driveshaft, be careful not to damage the bushing - arrow -.
‹› Do not cant driveshaft when removing, pull off from centering pin in horizontal position. Sealing ring in centering bushing - arrow - must not be
damaged.
CAUTION!
To prevent damaging the protective boot in the center bearing, remove and install the driveshaft in its fully extended position; likewise,
store it in this position.
‹› Two technicians are needed to remove the driveshaft.
-
Remove the driveshaft toward the rear and fully extended, if possible.