TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
Flywheel: Service and Repair
Dual Mass Flywheel and Sealing Flange, Transmission Side Assembly Overview
Dual Mass Flywheel and Sealing Flange, Transmission Side Assembly Overview
1
Bolt
‹› Replace
‹› 60 Nm plus an additional 90° turn further
2
Dual Mass Flywheel
‹› Removing and installing, refer to => [ Dual Mass Flywheel ] See: Dual Mass Flywheel
‹› Assembly is only possible in one position because of the offset holes
3
Bolt
‹› Tightening specification and sequence => [ Ribbed Belt Transmission Side Sealing Flange
- Tightening Specifications and Sequence ]
4
Intermediate Plate
‹› Must be located on alignment pins
‹› Do not damage or bend
‹› Is hooked in at sealing flange => [ Installing Intermediate Plate ]