1 Series E81 118i (N43) 3-door
Unlock lug (1) in direction of arrow, slide plug (2) out of DME
plug (3).
Unlock plug (1) and remove.
Withdraw profile seal from electronics box.
Installation:
To ensure leak-tightness, make sure profile seal is correctly
seated in electronics box.
Unlock carrier plate (1) and raise in direction of arrow.
Work step
Note:
Unlock plug on DME control unit and disconnect.
Unclip fuse.
Unlock plug connection in rear section of electronics box and disconnect.
Withdraw profile seal from electronics box.
Installation:
To ensure leak-tightness, make sure
profile seal is correctly seated in
electronics box.
RA Replacing engine wiring harness (N43)
BMW AG - TIS
18.01.2013 03:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -