Replacing Solenoid Switch for BMW 1 Series E81 120i (N43) 3-door Engine Electrical System
12 41 041
Replacing solenoid switch
Turn off ignition.
Remove starter motor.
Release nut (1).
Remove cable lug (2).
Caution!
Do not turn cable lug (2) while tightening down - risk of
short circuit to starter motor housing.
Tightening torque, 12 41 4AZ.
Release screws (1).
Remove solenoid switch (1) and spring (2).
Unhook pin (3).
Installation:
Check pin (3) for wear and apply grease.
RA Replacing solenoid switch
BMW AG - TIS
20.01.2013 03:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
