1 Series E81 120i (N43) 3-door
33 21 002
Removing and installing / replacing right
output shaft
Remove rear wheel.
Important!
Expand turning lock sufficiently to avoid damaging thread
when releasing collar nut.
Release collar nut (1), activate handbrake for this purpose.
Installation:
Replace collar nut, oil collar nut/wheel bearing contact surface
only and tighten down.
No oil permitted on thread of shaft journal or collar nut.
Tightening torque 33 41 1AZ
.
Secure collar nut by positive peening on flat areas of output shaft.
Remove tension strut if necessary
Release bolts and remove with washers (1).
Press output shaft off drive flange using a suitable tool; if
necessary, raise wheel carrier with workshop jack approx.
20 mm.
Installation:
Before installing output shaft, make sure that drive flange is fully
engaged in rear differential.
Replace bolts and washers (1).
Tightening torque 33 21 1AZ
.
RA Removing and installing / replacing right output shaft
BMW AG - TIS
20.01.2013 05:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -