1 Series E81 120i (N46T) 3-door
11 37 030
Removing and installing/replacing eccentric
shaft sensor (N46T)
Necessary preliminary tasks:
•
Remove cylinder head.
Important!
Screws can drop between the gearcase and the timing chain
into the timing drive (risk of damage).
Place a clean cloth between the gearcase and the timing
chain.
Remove screw of chain guide.
Tightening torque: 11 31 4AZ
.
Important!
Screws can fall into the chain drive.
Release screws on eccentric shaft sensor (1).
Tightening torque: 11 37 2AZ
.
RA Removing and installing/replacing eccentric shaft sensor (N46T)
BMW AG - TIS
20.01.2013 19:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
