1 Series E81 130i (N52K) 3-door
Unlock slide (2) in bore holes (1) and pull out of housing.
Unlock tab (3), pull contact carrier (4) in direction of arrow out of
housing.
Unlock and disconnect all plug connections of engine wiring
harness section in electronics box.
Illustration shows cylinder head cover.
Release screws and remove holder (1).
Tightening torque 12 52 1AZ
.
Work step
Note:
Unlock plug connections on control sensors and disconnect
Unlock plug on alternator and disconnect
Unlock plug connection on knock sensors and disconnect
Unlock plug on crankshaft sensor and disconnect
Unlock plug on starter motor and disconnect
Remove rear underbody protection
Unlock plug connections on monitor sensors and disconnect
Unlock plug on oil condition sensor and disconnect
Note:
Check stored fault messages.
Now clear the fault memory.
RA Replacing wiring harness section for engine (N52)
BMW AG - TIS
22.01.2013 03:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -