1 Series E81 130i (N52K) 3-door
16 11 030
Removing and installing or replacing fuel tank
(petrol/gasoline)
Recycling
Fuel escapes when fuel lines are detached. Have a suitable
collecting container ready.
Catch and dispose of escaping fuel.
Observe country-specific waste-disposal regulations.
Important!
Ensure adequate ventilation in the place of work!
Avoid skin contact (wear gloves)!
After installation of fuel tank/prior to first engine start-up:
•
Fill fuel tank with at least 5 litres of fuel.
•
Check ground connection at fuel filler neck to body for
continuity. If necessary, clean contact surface between
body and fuel filler pipe screw connection.
•
Check transfer function of suction jet pump.
Necessary preliminary tasks:
•
Draw off fuel from fuel tank
•
Remove rear seat bench
•
Remove guide tube for handbrake cables
•
Remove right wheel arch trim
•
Remove rear left and right underbody panelling
•
Remove left and right underbody cover
Release screws (1) and remove cover (2) from left and right
sides of fuel tank.
RA Removing and installing or replacing fuel tank (petrol/gasoline)
BMW AG - TIS
22.01.2013 03:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
