1 Series E81 130i (N52K) 3-door
Release screws.
Remove transmission bearing block (1).
Tightening torque 24 71 6AZ
.
Grip output flange (1) with special tool 23 0 020 .
Release nut with special tool 23 1 210 .
Tightening torque: 24 13 3AZ
.
Installation:
Apply a streak of Loctite 277 over complete thread width.
Replace nut and secure with a mandrel (8 mm) by caulking.
Detach output flange from output shaft.
Remove spacer.
Push special tool 24 4 360 onto output shaft (1).
Locking hooks (2) must enter completely.
RA Replacing output flange shaft seal (GA6L45R)
BMW AG - TIS
22.01.2013 04:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
