1 Series E81 130i (N52K) 3-door
•
E88: Remove V-strut on left and right
•
E88: Remove diagonal struts from mounting fixture
•
Remove lower section of steering spindle from steering gear
•
If necessary, disconnect plug connection from ride-height
sensor
•
If necessary, disconnect vacuum line from electric switchover
valve to engine mounts at T-piece
•
Disconnect both plug connections for pulse generators and
expose lines up to holder on spring strut
•
Detach plug connection for brake pad sensor and expose
lines up to holder on spring strut
Version with power steering:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Disconnect pressure line from vane pump
•
Detach return line from power steering cooler and expose line
up to connection on power steering gear
Version with active steering:
Disconnect plug connections (1) and unclip connecting line (2)
from front axle carrier.
Version with Electric Power Steering (EPS):
Disconnect plug connections (1) and expose wiring harness up to
engine carrier.
Installation:
Plug connections must audibly snap into place.
Make sure wiring harness is correctly laid.
RA Removing and installing complete front axle (with spring struts)
BMW AG - TIS
22.01.2013 04:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
