1 Series E81 130i (N52K) 3-door
Support swivel bearing with workshop jack and a suitable
mounting.
Release nut (1), remove holder (2) and remove screw.
Installation:
Screw head must point in direction of travel.
Replace self-locking nut.
Tightening torque 31 31 3AZ
.
Spread swivel bearing with special tool 31 2 230 .
Lower workshop jack and remove swivel bearing.
Installation:
Keep press fit of swivel gearing and spring strut in lower area
clean and free from oil and grease.
Installation:
Expand swivel bearing with special tool 31 2 230 , align by way
of gap to positioning pins (1) on back of spring strut and raise up
to stop.
Installation:
Make sure swivel bearing contacts stop (1) correctly.
RA Removing and installing/replacing left or right swivel bearing
BMW AG - TIS
22.01.2013 04:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
