1 Series E81 130i (N52K) 3-door
Repair solution for studs:
Release screw (1).
Raise locking nut (2) in area of bore and detach from front axle
carrier.
Drive out studs (3) in upwards direction and remove/feed out
through an opening in front axle carrier.
Installation:
Insert new screws from above.
Replace locking nut.
Tightening torque 31 12 1AZ
.
Replacement:
•
Remove both rubber mounts from stabilizer
RA Removing and installing/replacing front stabilizer
BMW AG - TIS
22.01.2013 04:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
