1 Series E81 130i (N52K) 3-door
Slowly lower workshop jack and remove rear differential towards
rear.
Important!
Adhere to the following installation sequence in order to
prevent distortion of the rear differential during installation and
thereby avoid potential complaints about noise.
Installation sequence:
1.
Install rear differential with workshop jack and special tool
33 4 420 .
2.
Insert bolts (1) (do not tighten down)
3.
Insert screw from rear and replace nut (2) (do not tighten
down)
4.
Lower workshop jack
5.
Tighten down screws (1)
Tightening torque 33 17 1AZ
.
6.
Tighten nut (2)
Tightening torque 33 17 1AZ
.
After installation:
•
Check rear differential oil level, correct if necessary.
RA Removing and installing/replacing rear differential
BMW AG - TIS
22.01.2013 05:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
