1 Series E81 130i (N52K) 3-door
Installation:
Check spring mounts (2, 3) for damage, replace if necessary.
Remove spring plate (1) and position with upper spring pad (2)
on coil spring.
Note:
Upper spring pad (2) must come into contact with end of coil
spring.
Version with rough road package: Install adapter as well.
Important!
Observe the following when installing and relieving tension on
coil spring:
-
Lower spring pad must be positively seated in the
designated receptacle in the camber arm
Note: Otherwise there is a risk of the coil spring jumping
out sideways.
-
Lower spring pad must come into contact with end of coil
spring (see arrow)
-
Lower spring pad must rest flush on last coil (see
broken line)
Align coil spring by way of spring plate to opening in side member
and relieve tension.
Remove special tools 33 5 011 , 33 5 012 and 33 5 013 ,
33 5 014 , 33 5 015 .
After installation:
•
Check headlight adjustment, correct if necessary
RA Removing and installing / replacing rear left or right coil spring
BMW AG - TIS
22.01.2013 05:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
