1 Series E81 130i (N52K) 3-door
Flushing brake system completely
Connect bleeder hose with collecting tray to bleeder valve on rear
right brake caliper.
Open bleeder valve and purge until clear, bubble-free brake fluid
emerges.
Close bleed valve.
Follow same procedure on rear left, front right and front left wheel
brake.
Note:
The clutch slave cylinder must also be scavenged in vehicles with
manual transmissions.
Switch off brake fluid changer and remove from expansion tank.
Check brake fluid level. If necessary, top up/draw off to max. level.
Close expansion tank.
Note:
Pay attention to rubber seal (1) in sealing cap.
After installation:
•
Reset CBS display according to factory specification
RA Replacing fluid in ABS/ASC+T brake system
BMW AG - TIS
22.01.2013 05:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
