1 Series E81 130i (N52K) 3-door
34 31 181
Removing and installing / replacing
expansion tank for hydraulic brake actuation
Necessary preliminary tasks:
•
Read and comply with General Information.
•
Remove lower section of microfilter housing
Note:
Extract brake fluid out of expansion tank. Use a suction bottle
used exclusively for drawing off brake fluid.
Do not reuse drawn out brake fluid.
Pull off supply hose (1) of clutch hydraulic system if necessary.
Unfasten plug connection (2) and disconnect.
Unlock quick-release fastener (3) and disconnect vacuum line.
Feed brake line out of rubber grommet and remove cover (4).
Unclip locking pin (1) from retaining lugs (2) and pull out locking
pin.
Pull expansion tank in direction of arrow vertically out of brake
master cylinder.
Important!
Check rubber plug in brake master cylinder for damage and
replace if necessary.
Push the expansion tank vertically onto the master brake
cylinder.
RA Removing and installing / replacing expansion tank for hydraulic brake actuation
BMW AG - TIS
22.01.2013 05:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
