1 Series E81 130i (N52K) 3-door
34 35 001
Replacing a brake pad sensor (front)
Important!
The brake pad wear sensor must be replaced once it has
been removed (brake pad wear sensor loses its retention
capability in the brake pad).
If a brake pad sensor that has already been ground has to be
replaced even though the minimum brake pad thickness has
not yet been reached, you must observe the following: The
new sliding contact must be filed down with a file to the same
length as the ground sliding contact.
Necessary preliminary tasks:
•
Remove wheel
Open plug housing (1).
Disconnect plug connection (2).
Feed brake pad sensor out of holders (3).
Press clip (1) together and detach brake pad sensor (2) in
direction of arrow from brake pad (3).
Installation:
Make sure clip (1) and brake pad sensor (2) are correctly seated
in brake pad (3).
RA Replacing a brake pad sensor (front)
BMW AG - TIS
22.01.2013 06:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
