1 Series E81 130i (N52K) 3-door
41 00 ...
Installation of a cavity seal with cavity foam
Sourcing reference for cavity foam (refer to BMW Parts Service).
Important!
The cavity foam may only be use for cavity sealing at the points at which cavity sealing is present as standard!
The following repair represents the replacement of a shaped part for the cavity seal by the use of cavity foam.
This type of cavity sealing is used at points at which shaped parts cannot be used for repairs.
This is the case when large amounts of heat occur (e.g. due to welding, soldering or tin-plating) in the direct vicinity or
at the point of the standard cavity sealing.
It is not possible here to install shaped parts for the cavity seal because of the fire risk!
To replace shaped parts with cavity foam at further locations, adopt the procedure shown here and adapt it to the
relevant conditions.
It must be ensured that the cavity is completely sealed off.
Note:
Check the accessibility for the spraying pipe of the cavity foam to the affected cavity after removing the
damaged part.
Properties of cavity foam:
-
2K-PUR foam, solvent-free.
-
Excellent flow capacity, enabling complete sealing of cavities.
-
Good strength, preventing slipping in cavities.
-
Low water absorption, preventing corrosion.
Important!
Observe processing instructions and safety precautions on the spray can!
-
Use by date on can.
Do not use the spray can after the use-by date has expired as the properties of the cavity foam would no
longer meet the requirements of the BMW Group.
-
Before applying to the vehicle, fill a clearly visible cavity of corresponding size with foam on a used part.
This enables an optimal dosage (i.e. spraying time) to be specified for filling the cavity on the vehicle with
foam.
-
Backing surface must be
clean and free from
dust,
grease,
oil and stripping agent.
-
Tape off open passages to visible areas with adhesive tape to prevent foam from escaping.
-
Application time after mixing: within 8 minutes.
-
Do not eat, drink or smoke during this operation.
RA Installation of a cavity seal with cavity foam
BMW AG - TIS
22.01.2013 06:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
