1 Series E81 130i (N52K) 3-door
41 61 014
Adjusting engine bonnet/hood
Read contents of Body, General.
The specified gap dimensions serve as the basis for adjustment
tasks.
Make unpainted surfaces visible by also moving the hinges. Touch
these up in the appropriate colour.
Note:
Carry over schematic representation to the relevant vehicle type.
Loosen screws (1) and (2) on left and right hinges.
Hood lid must be able to be moved.
Note:
If the adjustment range is not sufficient, release retaining
screws of engine hood hinge on body and move hinge.
Locks and retaining hook must snap correctly into place.
Adjust engine hood.
Note:
Vertical adjustment of engine hood to side panel by means of stop
pads.
Note:
Height adjustment of bonnet to front wall:
Release screw (1) and remove cover (2).
Height adjustment by turning at closing hooks (3).
RA Adjusting engine bonnet/hood
BMW AG - TIS
22.01.2013 06:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
