1 Series E81 130i (N52K) 3-door
Installation:
Mount trailing arms (1) at rear mounts (4) only, viewed in
direction of travel, with screws (2, 3).
Do not damage trailing arm with drill when drilling.
Drill spacer tube (1) with a 4 mm drill at three evenly offset points.
Place drill as near as possible to compensating bush (2).
Bores relieve tension on material of spacer tube.
Press out spacer tube (1) and compensating bush (2) with a drift.
Grease new spacer tube (1) for installation with Syntheso Glep I,
refer to BMW Parts Service. Drive new spacer tube (1) with a
rubber mallet into trailing arm mount (2).
Installation:
Make sure spacer tube (1) is not tilted when driven in.
RA Removing trailing arm, removing and installing or replacing mounting
BMW AG - TIS
22.01.2013 10:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
