1 Series 128i (N52K) Coupe
34 21 745
Removing and installing or replacing rear left
or right brake calliper (Teves)
Important!
The brake pad wear sensor must be replaced once it has
been removed (brake pad wear sensor loses its retention
capability in the brake pad).
Necessary preliminary tasks:
•
Remove wheel
•
Read and comply with General Information.
After completing work: Bleed brake system.
Press clutch pedal down to floor and secure with pedal support.
Note:
The pedal support may only be released when the brake lines are
reconnected.
This prevents brake fluid from emerging from the expansion tank
and air from entering the system when the brake lines are opened.
Important!
Grip brake hose at square head (2) so that connecting piece
cannot rotate in retaining bracket.
Disconnect brake hose from brake line (1).
Installation:
Tightening torque 34 32 1AZ
.
Detach brake hose from brake calliper (3).
Installation:
RA Removing and installing or replacing rear left or right brake calliper (Teves)
BMW AG - TIS
17.01.2013 17:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -