1 Series 128i (N52K) Coupe
Installation:
Slowly pull out cable ends (2).
Press rubber collar (1) into groove with special tool 00 9 321 .
Installation:
Cover bowl (2) must snap into place 4 times.
After installing, carefully check cover bowl at clips for secure fit.
There must be no discernible gap between the sealing lip of the
cover bowl and the side panel in the area.
Make sure rubber collar (1) is correctly seated (watertightness).
Installation:
Catches (1) on ejector (2) must not be damaged.
Check protective cap (3) for correct seating.
(Watertightness!)
RA Replacing cover bowl
BMW AG - TIS
17.01.2013 18:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
