1 Series 128i (N52K) Coupe
51 14 110
Removing and installing/replacing rear model
designation
Important!
The Instructions for number/letter combination cementing
serve as the basis for these repair instructions and must be
followed without fail.
Fitting dimensions (E82/E88):
Stick on adhesive tape (1) horizontally according to dimension "A".
Mark reference point (2) according to dimension "B".
Position model designation at reference point (2) and stick on.
Dimensions:
A= 23.5 mm
B= 26.5 mm
Note:
Measurements C, D and E are for information purposes only, as determined by carrier film.
RA Removing and installing/replacing rear model designation
BMW AG - TIS
17.01.2013 18:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
