1 Series 128i (N52K) Coupe
51 43 148
Removing and installing or replacing panel
for left or right door pillar
Lever out cap (6) and release screw underneath.
Remove coat hook (7).
Release side trim panel (1) at retainers (2) and clip (3).
Release trim panel (5) at clips (4) and remove in downward
direction.
Installation:
If necessary, replace faulty clips (3 and 4).
Complete removal only:
Lever out cap (1).
Release screw (2) and detach seat belt strap.
Tightening torque 72 11 5AZ
.
Feed out seat belt strap from trim for door pillar.
Installation:
Check that spacer bushing (3) and rubber ring (4) are in correct
position.
Installation:
Guides (1) on trim (2) must not be damaged.
RA Removing and installing or replacing panel for left or right door pillar
BMW AG - TIS
17.01.2013 19:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -