1 Series E87 118d (M47T2) 5-door
12 51 200
Replacing wiring harness section for injectors
(M47TU2)
Necessary preliminary tasks:
•
Read fault memory of DDE control unit
•
Switch off ignition
•
Disconnect battery negative lead
•
Remove acoustic cover at front
Unfasten screws.
Remove rear acoustic cover.
Unlock fasteners (1) from below and slide upwards approx.
10 mm.
Unlock locks (2) in direction of arrow.
Remove cover (3).
Disconnect plug (1) from DDE control unit.
Pull profile seal of wiring harness out of electronics box.
Installation:
To prevent leaks, you must install profile seals correctly.
RA Replacing wiring harness section for injectors (M47TU2)
BMW AG - TIS
18.01.2013 08:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
