1 Series E87 118d (M47T2) 5-door
Necessary preliminary tasks:
•
Switch off ignition
•
Layout of common rail system
•
Remove intake air manifold
•
E46, E87 only:
Remove fan cowl
Disconnect plug (1) from pressure regulator of H.P. pump.
Release clamp (2).
Detach fuel feed line from H.P. pump.
Installation:
Replace clamp (2).
Release fuel return line (3) on H.P. pump. (Banjo bolt).
Installation:
Replace seal of banjo bolt.
Tightening torque 13 53 14AZ
.
Release union nut (4) on H.P. pump and union nut on H.P.
accumulator with special tool 13 5 020 .
Remove H.P. line.
Tightening torque 13 53 8AZ
.
Note installation position of rubber mount on H.P. line.
Release nuts (1) on H.P. pump.
RA Removing and installing/replacing high-pressure pump (M47TU, M47T2)
BMW AG - TIS
18.01.2013 08:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -