1 Series E87 118d (M47T2) 5-door
25 11 101
Replacing shift rod
Necessary preliminary tasks:
•
Remove rear underbody protection.
•
Remove transmission cross-member.
•
Remove transfer case (AWD).
Detach locking clip (1).
Disconnect shift rod (2).
Installation:
Grease shift rod.
Grease, refer to BMW Service Operating Fluids.
Unlock bearing pins (1) from selector arm in direction of arrow
and remove.
Installation:
Grease bearing pin.
Grease, refer to BMW Service Operating Fluids.
Lever spring washer (1) out of groove and push a little towards
rear.
Press dowel pin (2) in direction of arrow out of shift rod joint and
remove shift rod (3).
Installation:
Grease ball of selector shaft.
Grease, refer to BMW Service Operating Fluids.
Replace spring washer (1).
RA Replacing shift rod
BMW AG - TIS
18.01.2013 09:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
