1 Series E87 120d (N47) 5-door
Gearbox (HP 19):
Reposition special tool 11 8 181 on gearbox (HP 19).
Fit special tool 11 8 183 at gearbox bolts (1).
Adjust special tool 11 8 182 at flywheel toothing (2).
E83:
Reposition special tool 11 8 181 on H-gearbox.
Detach exhaust system bracket (1) from transmission.
Fit special tool 11 8 183 at gearbox bolts (2).
Adjust special tool 11 8 182 at flywheel spline.
Release screws (1).
Remove vibration damper.
Tightening torque 11 23 2AZ
.
Installation:
Replace screws.
Replace radial shaft seal at front.
Tighten screws crosswise.
Assemble engine.
Important!
Do not run engine without ribbed drive belt.
Risk of damage! to vibration damper.
RA Removing and installing/replacing vibration damper (N47, N47S)
BMW AG - TIS
22.01.2013 13:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -