1 Series E87 120d (N47) 5-door
13 53 570
Replacing pressure regulator on pressure
accumulator of injection system (N47)
Necessary preliminary tasks:
•
Read fault memory of DDE control unit
•
Switch off ignition
•
Remove acoustic cover
•
Remove all pressure lines
•
Remove pressure accumulator
Recycling:
Catch and dispose of escaping fuel.
Observe country-specific waste-disposal regulations.
Installation:
Pressure regulator may only be used once!
Pressure regulator must be replaced (cutting seat gasket) after
screw connection has been released.
Positioning before final tightening!
Grip at hexagon head (1) when removing pressure regulator.
Release hexagon screw connection on pressure accumulator.
Installation:
Secure position of pressure regulator and grip at hexagon
fitting (2).
Tightening torque 13 53 3AZ
.
RA Replacing pressure regulator on pressure accumulator of injection system (N47)
BMW AG - TIS
22.01.2013 14:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -