1 Series E87 120i (N46T) 5-door
![background image](/bmw/1_Series_E87/120i_N46T_5-door/page-453001.png)
32 13 070
Removing and installing (replacing) electric
steering gear (EPS)
Important!
Steering gear:
Check connection of steering gear for corrosion, clean
contacts if necessary. The steering gear must be replaced if
the corrosion is too far advanced.
Connecting cable:
In the event of moisture/corrosion inside the two plug
connections, check the insulation of the connecting cable. If
the insulation reveals any noticeable/striking features, it will be
necessary to replace the part. Otherwise it will be sufficient to
replace the contacts or plug housing.
Note:
In a warranty case you must always provide a fault memory
printout, even where there is no fault memory entry, with the
defective part.
Necessary preliminary tasks:
•
Disconnect battery negative lead
Note: High-current-carrying lead laid with permanent positive
connection (80 A fuse protection).
•
Remove front underbody protection
•
E88, E93: Remove V-strut on left and right
•
Remove lower section of steering spindle from steering gear
•
Remove both tie rod ends from swivel bearing
•
Replacement: Remove both tie rod ends from steering gear
RA Removing and installing (replacing) electric steering gear (EPS)
BMW AG - TIS
25.01.2013 05:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -