1 Series E87 123d (N47S) 5-door
Installation:
Markings (5) on suction line and vane pump connection must
match up.
Release screws (1, 2) and remove vane pump towards bottom.
Installation:
1.
Insert screws (1, 2) (do not tighten down)
2.
Tighten first screw (2) and then screws (1) to 2 Nm
3.
Tighten down screws (1)
Tightening torque, 32 41 6AZ
.
4.
Release screw (2) and check screw fastening point for gap
freedom
5.
Tighten down screw (2)
Tightening torque, 32 41 6AZ
.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
RA Removing and installing (replacing) vane pump for power steering (N47)
BMW AG - TIS
26.01.2013 09:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
