1 Series 125i (N52K) Convertible
11 37 005
Removing and installing/replacing eccentric
shaft (N52K)
Special tools required:
•
11 4 481
Necessary preliminary tasks:
•
Remove cylinder head cover
•
Remove intermediate lever
If necessary, move eccentric shaft (1) on twin surface to
minimum lift (2).
Note:
All bearing caps (1 and 2) of eccentric shaft are marked with
numbers from 1 to 6 (1 for 1st cylinder to 6 for 6th cylinder).
Bearing cap 6 (1) is provided with a stop.
Release screws on bearing cap 6 (1).
Release screws on bearing caps 1 to 5 (2).
Set all bearing caps down in special tool 11 4 481 in a tidy and
orderly fashion.
Remove eccentric shaft with gentle tilting and turning movements.
RA Removing and installing/replacing eccentric shaft (N52K)
BMW AG - TIS
17.01.2013 05:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -