1 Series 125i (N52K) Convertible
Lift out plug connection (2), fuse carrier (3) and wiring harness
grommet (4) from electronics box (1).
Installation:
Make sure wiring harness grommets (4) are correctly seated in
electronics box (1).
Unlock DME control unit at holders (1) and raise slightly.
Pull tab (3) in direction of arrow out of housing and disconnect
plug connections (2) on DME control unit.
If necessary, press locking tabs (1) in direction of arrow and pull
contact carrier (2) out of housing.
If necessary, press locking tab (1) in direction of arrow and pull
contact carrier (2) out of housing.
RA Removing and installing/replacing electronics box
BMW AG - TIS
17.01.2013 05:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -