1 Series 125i (N52K) Convertible
17 11 370
Removing and installing/replacing cooling
loop for power steering
Warning!
Danger of scalding!
Only perform this work after engine has cooled down.
Important!
When working on the oil, coolant or fuel circuit, you must
protect the alternator against contamination.
Cover alternator with suitable materials.
Failure to comply with this procedure may result in an alternator
malfunction.
Necessary preliminary tasks:
•
After completing this operation, check fluid level in tank of
power steering system.
•
Remove radiator
Press lines (1) in direction of cooling loop, pull black locking ring
towards rear. Keep locking ring pressed and detach lines (1) from
cooling loop.
Important!
Catch and dispose of emerging fluid.
Press lock (2). Pull cooling loop (3) of power steering towards
rear out of holder.
RA Removing and installing/replacing cooling loop for power steering
BMW AG - TIS
17.01.2013 07:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -